(3) Fit the cylindrical spacer blocks to the supports of xTool D1. (2) Fit the rubber ring to each cylindrical spacer block. (1) Remove the rubber ring from each support. Fit the cylindrical spacer blocks as follows: Use the cylindrical spacer blocks supplied by Makeblock. To use the rotary roller engraving module, you need to fit cylindrical spacer blocks to the supports of xTool D1. Fit cylindrical spacer blocks to the supports of xTool D1. Install the rotary roller engraving module on xTool D1ġ. Click Frame to see whether the pattern is to be engraved in the expected position of the material. Draw a square on the canvas on LightBurn.ĥ. You can move the laser head to place the center point in the position where you want to start engraving.Ģ. The center point of the cross-shaped light beams is the start point for framing. Put down the ranging rod to set the height of the laser head. Place a material to be engraved in the working area. The following device information is displayed after the file is successfully imported.ġ. Click Import to import the file xTool_D1_Prefs.ģ.

If you choose Import Prefs, the original configuration is overridden.Ģ. Make sure that you start to configure xTool D1 in this way instead of choosing Import Prefs from the menu.

Open LightBurn, click Devices on the Laser The version must be V1.0.0.4 or later.īefore you configure xTool D1, download the configuration file first:ġ. Note: Make sure you use the latest version of LightBurn. If you are a new user, you have a 30-day free trial. Go to to download the latest version of LightBurn, and install it. Check whether the version is updated to the latest one, that is, 1.0 B3. Select the serial port that xTool D1 uses.ģ. Click Update Now, and wait for the update to complete.ġ. Select the serial port that xTool D1 uses and click Connect.ħ.

If a new version of Laserbox basic is found, update it to the latest version.Ħ. Double-click the Laserbox basic icon to open it. Use the USB cable to connect xTool D1 to your computer.ģ. Perform the following steps to update the firmware of xTool D1:Ģ. To ensure the compatibility of xTool D1 with LightBurn, you need to update the firmware of xTool D1 to version V1.1.0 B3 that supports LightBurn, and to update the firmware of xTool D1, you need to install Laserbox basic of version V1.1.1 or later. If errors occur due to incompatibility, you can contact our after-sales service for technical support. The firmware of xTool D1 has been tested in detail by Makeblock Co., Ltd, but incompatibility with the software or hardware may still occur. shall bear no responsibility for any loss caused due to the operation of LightBurn. LightBurn is third-party software, and therefore Makeblock Co., Ltd. If you need to control xTool D1 through LightBurn, download the official release of the LightBurn software.

Xtools pro itl bottom bracket tap